INSTALLATION RECOMMENDATION

MAXX STEELBINDER (Cupped Head Sealers) &
HWH STEELBINDER Sealers & KWIKSEAL II WOODBINDER


1. Select the proper screw gun for installing self drilling fasteners.

2. Set the magnet in the driving socket to the proper depth. Socket must bear securely on the hex washer face of the fastener.





3. Use depth sensing nosepiece on screw gun to allow proper seating of fastener.
Do not overdrive. (See illustration.)

MAXX STEELBINDER		HWH STEELBINDER & KWIKSEAL II WOODBINDER
CORRECT Sealing material slightly visible at edge of metal washer. Assembly is weather tight.
UNDERDRIVEN Sealing material not compressed, Assembly losse.
OVERDRIVEN Sealing material extruded beyond edge of washer. Washer deformed.

4. Drive fastener perpendicular to surface.

MAXX STEELBINDER		HWH STEELBINDER & KWIKSEAL II WOODBINDER
CORRECT	INCORRECT	CORRECT	INCORRECT

5. Select extension cords with the correct wire size. See table below.

RECOMMENDED MINIMUM WIRE GAUGE* FOR EXTENSI0N CORDS

6. Do not force the fasteners. Apply only enough end pressure to allow drill point to cut efficiently.