Sealtite Building Fasteners

#14 TYPE 17 WOODBINDER®

• Designed to be used as a "rescue screw." This fastener will replace nails or smaller diameter fasteners that have loosened & backed out of steel roofing over time.

• 5/16 HWH with bonded sealing washer will completely cover existing hole, even if elongated by movement in the metal roof.

• Type 17 point will help clean the existing hole so that oversized threads can tap & generate maximum holding strength.

• EPDM rubber is vulcanized to the steel washer to prevent delamination & form an excellent seal even when driven at an angle.

• Mechanical zinc plating provides superior corrosion resistance versus electro-plating under barrier coatings.

SIZE	HEAD STYLE	CARTON QTY.	WEIGHT/M
14 X 1"	5/16" HWH	2000	19.0
14 X 1-1/4"	5/16" HWH	2000	15.7
14 X 1 1/2"	5/16" HWH	1500	23.0
14 X 2"	5/16" HWH	1500	27.5
14 X 2 1/2"	5/16" HWH	1000	32.0

TECHNICAL INFORMATION	POINT DIAMETER	MAJOR DIAMETER	MINOR DIAMETER	HEAD ACROSS FLATS	ULT. TENSILE STRENGTH	MIN. TORSIONAL STRENGTH	NOMINAL SHEAR STRENGTH
	30 SHARP	.254/.248	.185/.178	.312/.305	4270 LBS.	125 IN-LBS.	2997 LBS.

SUBSTRATE
MATERIAL			3/4" PLY.	5/8" PLY.	1/2" PLY.	7/16 OSB	YELLOW PINE		SPRUCE PINE FIR	HEMLOCK FIR
HRS Primed Only
16	14	12
.065	.070	.106					2X	1X	2X	2X
800	1250	2017	843	648	378	294	1187	746	651	669

(1) FULL PENETRATION
(2) 1" PENETRATION

PULL OVER STRENGTH VALUE (LBS. ULT.)	DESIGNATION	MATERIAL
	DESIGNATION	AZ55 GALVALUME				G-90 GLAVANIZED
	NOM. GAUGE	29	26	24	22	20
	THICKNESS	.015	.019	.024	.032	.038
BONDED WASHER (14mm)		495	780	1078	1355	1608
(.398/.432 HWH DIA)			722	1040	1197	1419

NOTES: All strength values shown below are ultimate values, expressed in LBS. Apply an appropriate safety factor to obtain design limits.

Application


Hex Washer Head with EPDM rubber will completely cover the existing hole to provide a watertight seal.		The Type 17 point will clean the existing hole of metal burrs & the oversized threads will generate increased holding strength.